Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How do I wire a texecom veritas r8 alarm panel
22-05-2012, 08:58 PM
Post: #1
How do I wire a texecom veritas r8 alarm panel
Guest - 15-04-2010 04:08 PM

I have all the accessories, I just dont know how to wire the tampers


--------------------------------------------------------------------------------
RE: How do I wire a texecom veritas r8 alarm panel - admin - 15-04-2010 04:09 PM

As with all good alarm systems the tampers are a normally closed circuit only going open circuit when a siren cover or control panel is lifted thus opening the contact. If you like, tampers can be run off a single sector (preferably a 24 hr sector that is active even if the control panel is in the off mode) in the control panel and thus can be wired in line and if there is a "break" anywhere in that line it will cause the control panel to go into alarm. If the control panel comes with end of line resistors, ensure these are fitted to the furtherest point of the tamper circuit. Remember only use one resister per alarm panel sector. Use only good quality copper cabling as other types can deteriorate over time and build up resistance in the cabling.
Find all posts by this user
Quote this message in a reply
Post Reply 


Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  Texecom Ricochet Professional Test admin 0 93 17-06-2014 11:47 AM
Last Post: admin
  Texecom Premier 24 Bench Test admin 0 91 17-06-2014 11:43 AM
Last Post: admin
  Texecom Veritas R8 keypad malfuntioning jamesvscott@hotmail.com 1 464 14-11-2013 08:01 PM
Last Post: Rem Alarms
  reset veritas 8? skywalker 3 662 17-02-2013 06:24 PM
Last Post: electrician
  veritas 8 alarm battery change Guest 3 10,484 15-08-2012 09:05 PM
Last Post: GB Surveillance
  Texecom reigistered engineer's forum Rem Alarms 6 1,169 15-06-2012 12:48 AM
Last Post: PSE Security
  Cannot reset my Veritas R8 plus Panel Guest 4 2,575 03-06-2012 03:57 PM
Last Post: engels7570
  Change code for the Verita alarm system Old Posts 1 1,099 02-06-2012 11:30 PM
Last Post: Old Posts
  texecom veritas keypad dead during power-cut Guest 4 3,144 28-05-2012 09:45 PM
Last Post: engels7570
  Veritas code problem - can you help? Old Posts 0 1,367 22-05-2012 10:36 PM
Last Post: Old Posts

Forum Jump:


User(s) browsing this thread: 1 Guest(s)