Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
powermax+ texecom oddesy
10-10-2012, 10:47 PM,
powermax+ texecom oddesy
hi inherited a texecom bell box after upgrading the alrm system to a powermax+
have tried to wire it and keep getting tamper issue showing. i understand that i need to introduce a resistor into the tamper circut in the box. can anyone explain please?have wired in powermax+ wiring as this
hold- -d, ext -b, int -s, +12v -a, zone30 -c, have 2kohm resistor which i removed from term zone30&gnd in powermax.
also i have heard ther is a way of adding addl red led to the box for an alternative indicator to show alarm armed.. ie 12v led to 1k resitor 24 gauge wire using +12v and pgm?
any adviceplease
11-10-2012, 11:13 AM,
RE: powermax+ texecom oddesy

You can buy a ready assembled flashing red led from any motor factors, simply wire it up.

Need to get back to you on the connections.

Keep an eye on your post.

11-10-2012, 11:53 AM,
RE: powermax+ texecom oddesy

Are you using the Visonic Powermax (wireless) ? Can't see your connections listed, Only + & - to the sounder.

11-10-2012, 12:16 PM,
RE: powermax+ texecom oddesy
It's probable that the resistor at 30 should remain intact across the terminals. Can you meter these terminals to determine which is positive and negative ?
11-10-2012, 01:54 PM,
RE: powermax+ texecom oddesy
Try this:-

Com + to A
D to PGM-
Ext - to B
C to Z30-

Link S and B at sounder. leave resistor intact at Z30 terminals.

Provided Pgm - is a permanent negative and Z30 is programmed as 24hr.

Possibly Related Threads...
Thread Author Replies Views Last Post
  texecom azura 360 to A1 AJ6000 panel admin 0 297 21-05-2012, 10:19 PM
Last Post: admin
  texecom odyssey 4e & scantronic 9651 wiring Help REQ admin 0 277 21-05-2012, 10:04 PM
Last Post: admin
  Texecom's Odyssey 3 sounder, OLD Bench Test admin 0 236 21-05-2012, 09:41 PM
Last Post: admin

Forum Jump:

Users browsing this thread: 1 Guest(s)