Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
9448 will not re-arm after tamper fault
28-12-2017, 03:35 PM,
#1
9448 will not re-arm after tamper fault
Hi Guys, I had a carpet fitted which caused a tamper fault, I cleared the tamper but now the alarm will not set. Once I enter the code it cycles through the leds untill the code is put again. How do I make the alarm set again ?

many thanks Mac
Reply
28-12-2017, 08:45 PM,
#2
RE: 9448 will not re-arm after tamper fault
Sounds like a blown fuse. Are the sensors not lighting up?
Reply
28-12-2017, 09:10 PM,
#3
RE: 9448 will not re-arm after tamper fault
Thanks for the reply,

The sensors are not lighting so I've changed two fuses I can see inside the panel, I didn't have a 1A so put in a 1.25A in would make a difference ?
Reply
29-12-2017, 02:33 PM,
#4
RE: 9448 will not re-arm after tamper fault
Ideally you should swap it for the correct rating but it will do for now.
Reply
29-12-2017, 05:26 PM,
#5
RE: 9448 will not re-arm after tamper fault
Ok, I got the correct fuse and I still cant get it to re alarm It just cycles through the LEDS when I put the code in, Any Ideas ?

Thanks
mac
Reply
29-12-2017, 06:42 PM,
#6
RE: 9448 will not re-arm after tamper fault
Are the sensors lighting up?
Reply
29-12-2017, 07:05 PM,
#7
RE: 9448 will not re-arm after tamper fault
Nope nothing
Reply
29-12-2017, 07:16 PM,
#8
RE: 9448 will not re-arm after tamper fault
You've got a short somewhere, the fuse is blowing as soon as you replace it. Go back to the damaged cable and make sure no wires are touching each other. It's entirely possible there's more than one damaged bit
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Accord8 Tamper Fault CycleOps 26 1,750 20-11-2012, 08:21 PM
Last Post: CycleOps
  galaxy 504 mod tamper 101? stewalker 8 891 20-08-2012, 11:41 AM
Last Post: Specialist
  securitech trident, tamper fault admin 0 243 21-05-2012, 09:17 PM
Last Post: admin
  CQR Bell tamper fault admin 1 372 21-05-2012, 09:16 PM
Last Post: admin
  C+K securitech alarm Tamper light Flashing admin 0 435 21-05-2012, 09:15 PM
Last Post: admin
  Castle care tech Euromini fault admin 0 262 21-05-2012, 09:13 PM
Last Post: admin
  Ademco Tamper Light Help admin 0 282 21-05-2012, 09:12 PM
Last Post: admin
  pyronix stirling 10 fault admin 0 252 21-05-2012, 09:10 PM
Last Post: admin
  Advantage ZX6 Control Panel Tamper admin 0 413 21-05-2012, 09:09 PM
Last Post: admin
  abacus aplique 6/14 fault admin 0 204 21-05-2012, 09:09 PM
Last Post: admin

Forum Jump:


Users browsing this thread: 1 Guest(s)